Упаковка:

10 kg, 5 kg, bucket 20 kg

MAXGUARD GT GREEN SF

Tooling gelcoat based on a special vinylester resin.

The base resin recipe ensures that the mould surface has maximum mechanical properties, high gloss and flexibility.

Intended for spraying.

  • Brookfield viscosity at 23°C (10 rpm) – 7500 mPas,
  • Viscosity (plate and cone) at 23°C – 230 mPas,
  • Gelling time at 23°C (2.0% MEKP–50) – 7 min.
  • HDT – 110°C,
  • Hardness – 35-40 Barcol.

Maxguard GT Green SF is a green tooling gelcoat based on special vinyl ester resin.

The SF version is suitable for spraying.

Recommendations:

  • The temperature of all materials and tools should be within the range of 18 – 25°C. If the temperature is too low, the gelcoat will not cure properly. The uncured gelcoat (also due to the addition of too little hardener or too thin a layer) will cause many subsequent defects on the surface.
  • The gelcoat must be gently mixed in its original packaging before use.
  • Cast the required amount of gelcoat into a replacement, clean vessel, add 2.0% hardener (MEKP) and mix thoroughly.
  • The spray version (SF) should be applied in several layers (approx. 0.2 mm), wet on wet. As small nozzle and as low pressure as possible should be used for spraying. A short gap of 2-4 minutes between the layers allows air bubbles to be removed from each surface. The final wet layer thickness should be 0.8 – 1.0 mm.
  • The layer of hardened gelcoat should be approx. 0.8 mm thick.
Упаковка:

10 kg, 5 kg, bucket 20 kg

Customers rewievs (0)

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.

Ask about product

MAXGUARD GT GREEN SF

    * required fields